New TAZR add on

[Escape.idiocracy]

If the transmission has been “restricted” for as long as it’s been operating and it’s “learned” this way,..now it has this harness that shuts off TC, shouldn’t the transmission be reflashed to start the learning all over again?
It sounds like rev hang or gears not shifting is a result of what it’s “learned”. If a reflash isn’t done, I think the transmission will require the additional 10k kms (6k miles) to adapt to the new driving style.

Transmission can be reset with jscan.

Sponsored

 

[Minty JL]

If the transmission has been “restricted” for as long as it’s been operating and it’s “learned” this way,..now it has this harness that shuts off TC, shouldn’t the transmission be reflashed to start the learning all over again?
It sounds like rev hang or gears not shifting is a result of what it’s “learned”. If a reflash isn’t done, I think the transmission will require the additional 10k kms (6k miles) to adapt to the new driving style.

Yeah I have had mine hang once or twice. If it persist then I will grab the Autel and do a relearn.

 

[ShastaJT6]

They say, in the product video, that that feature is always on.

Confirmed by email response as well.
"It blocks all access to the RF Hub including key pairing even when it's turned off."
Wonder if thats a physical disconnect by the wiring harness. Pretty cool either way.

Im all about additional layers of security. Sucks to hear that some folks are already having problems with these units (based on earlier comments here) but something I will add to the shopping list and buy in a few months when they have worked out the post-launch kinks.

 

[EddyArnold]

Diesel guinea pig!

 

[jav_eee]

I’m still waiting for them to write back about my issue.

 

[Minty JL]

Diesel guinea pig!

Can't wait to hear the results

 

[EddyArnold]

delivered/updated/installed

but it's dark and rainy, so I only drove around the neighborhood just to make sure I didn't break anything... I'll have to get out and play later in the week

 

[EddyArnold]

Oh, what's this? (I didn't touch any of it!)

 

[Rusty PW]

Oh, what's this? (I didn't touch any of it!)

Hmmmmm..........
Where did you find this?

 

[EddyArnold]

Hmmmmm..........
Where did you find this?

Z Auto update tool, there was a config tab.

 

[Rusty PW]

Z Auto update tool, there was a config tab.

Looks like you can play with the shift settings. And wonder if that throttle setting is the pedal response. Then you wouldn't need a pedal monster.

 

[Idlethunder]

Z Auto update tool, there was a config tab.

Did you do anything special for the update tool to recognize the NoLimit device? After trying several times using the cable they supplied and one of my own, the update tool could not see the device.

 

[EddyArnold]

Did you do anything special for the update tool to recognize the NoLimit device? After trying several times using the cable they supplied and one of my own, the update tool could not see the device.

Mine wouldn't connect too until I rebooted with it plugged in... Give that a try!

 

[Idlethunder]

Mine wouldn't connect too until I rebooted with it plugged in... Give that a try!

Will do, thank you!

From what I saw on their site it looked like there were only two firmware options, original 24.0.5 and beta 24.0.6. Did you install the beta? They didn’t list much information about either.

 

[EddyArnold]

Will do, thank you!

From what I saw on their site it looked like there were only two firmware options, original 24.0.5 and beta 24.0.6. Did you install the beta? They didn’t list much information about either.

Yeah I went with the beta

Sponsored