Those complaining about the steering... get the Fox Steering Stabilizer

[KurtP]

Old thread I know, but has anyone had the TSB fix AND added fox stabilizers? I’m curious how this turned out and if the result is a particularly firm steering (in a good way) or a poor experience (way too stiff).

I do. 4” lift, fox/mopar damper, tsb, caster at 6°. Drives great. Watch the vid:

https://www.jeepgladiatorforum.com/forum/threads/let’s-talk-about-mods.40565/post-664277

Sponsored

 

[Trailman]

I do. 4” lift, fox/mopar damper, tsb, caster at 6°. Drives great. Watch the vid:

https://www.jeepgladiatorforum.com/forum/threads/let’s-talk-about-mods.40565/post-664277

Awesome, thanks!

You may mention this in the video (which I will watch), but did you get the TSB first? I'm assuming if I went in with a Fox stabilizer on the truck and told them I wanted the TSB, they'd blame me for changing out the stabilizer.

 

[KurtP]

Awesome, thanks!

You may mention this in the video (which I will watch), but did you get the TSB first? I'm assuming if I went in with a Fox stabilizer on the truck and told them I wanted the TSB, they'd blame me for changing out the stabilizer.

I had damper and 37’s. Zero issues.

 

[Holoscape]

Did you guys have to buy another bolt closest to the wheel because it’s a carriage bolt? The ifp eyelet is not big enough for the stock bolt in my case for the stock location.

 

[MOJAVEC22]

My concern with this particular kit is that it leaves the (expensive) stabilizer below the axle, exposed to rock damage. I’m wondering whether you could use a JL stabilizer relocation bracket along with the JK version of the Fox TS stabilizer (985-02-128 or 985-02-122) to move it in line with the axle, and above the tie rod. There are 1-1/2” and 1-5/8” tie rod brackets readily available, but the JT measures just under 1-5/8”.

Any word on this? Looking into it now. I want the stabilizer above the steering and axle as well. Want the FOX-985-02-122 since it’s suppose to fit the JL. But I figured the JT tie rod was 1 5/8. JT is 40mm apparently but it should snug up. Also not sure what to use on the axle side mounting relocation. If synergy made one I would go for that one.

Sponsored