What did you do TO your Gladiator today? [ADMIN WARNING: NO POLITICS, NO GUN TALK]

[Blade1668]

The culprit from the air box critter clean out a couple weeks ago is no confirmed to be a small chipmunk. I saw the punk climb up the tire and go under the fender liner. I quickly scared it out of there, and it had already gathered more crap in the box. Cleaned it out again, and threw this peppermint pack under the filter. I used peppermint spray on the tires and a few spots under the hood that wouldn’t hurt anything. Now I need to order one of those stupid noise makers. Dammit chipmunk!

If you swing back though Stony Lonesome again I can give you a few things that will take care of your chipmunk problems.
Here's a picture of one that decided she wanted me to set down for a hour or so.

Sponsored

 

[Blade1668]

After getting back from dealership, the fuse bar to fuse box. Fried one of fuses on it. I will recommend getting a replacement fuse bar or jumper with fuse to keep in glovebox then you will not need it. (One of my Army buddy's had his at dealership getting the clutch replaced and they fried the same part on his a few days after mine.)
Shuffled gear back in, cleaned out fridge freezer and sanitized it. Relocated RTT to 4wheeler trailer, taking about 200 lbs off. If I could drop the pounds off like my JT did that would be great.

The put original rear gate / ramp back on trailer.
Calibrated for correct tire size with TASER, found it was off more than expected. Damn I should have got the TASER a few years back. The odometer would be about 10k less. It was recording 1.1 mile per mile traveled.

 

[Planerdude]

Got it back with mostly everything installed. Lockers, 4.88 gears, trussed, front and rear drive shafts, dynatrac ball joints, ppe transmission pan.

Hows that ppe trans pan working out ?
Do you think exhaust wrap on the y pipe would Make a difference with the heat?

 

[FijiKid]

These worked out quite well for me.

TY! Need these also. Curious how looks on the “curved” holes? Pic?…. Ty!!!

 

[mtbjeeper]

Took advantage of some really unseasonable weather here in the NE. Wash and air dry.

 

[DanJT]

To help with engine bay heat I installed S&B's hood scoops. There are plugs to cover the openings in the event of heavy rain.

And found some Gladiator vinyl stickers and heat pressed them to my headrests.

Under hood shot of scoops.

 

[Minty JL]

Quick lil trans tune

Only because there isn't jack shit fuck all and nothing for the '23s

 

[Commodus]

Only because there isn't jack shit fuck all and nothing for the '23s

Really very immature and childish can be expressed much better with a little education

 

[mx5red]

Hows that ppe trans pan working out ?
Do you think exhaust wrap on the y pipe would Make a difference with the heat?

Since you’re trussed I’m guessing you’re off-roading… I’d very seriously consider putting an oil pan skid over all that sensitive stuff you’re showing in your picture..

 

[NewGladdyOWNR]

Added a few things:
Apex Autolynx
MetalCloak tie rod/drag link: ended up reinstalling my Bilstein dual stabilizer setup as the rock sport stabilizer allowed for too much bump steer
JCR half rack: scored for $200 on FB marketplace
Mopar performance rock rails: scored for $200 on fb marketplace. Had a couple marks but used some krylon textured black spray paint. Perfect match.
Tactik 7” light bar: relocated to my bed rack

 

[LawDawg]

Bought it.

 

[NotSo Bright White]

A software company paid for my graphics so I had them installed yesterday. Thanks to Don @pixeldecals!

 

[mendiola21]

Installed some new grab handles made by @darksidedesign. They look good and blend the Red/Black Rubicon interior with my Anvil Rubicon perfecty. Great Build Quality. Many Colors to choose from to match your Jeep.

 

[Minty JL]

Really very immature and childish can be expressed much better with a little education

Well your assumptions based on my choice of vernacular is rather ungracious.

Is that better cupcake????? Trying to flex your education and writing skills on an automotive forum just makes you appear as an utter tool bag or sky crane (worlds largest tool), respectfully.

Cheers!

 

[WILDHOBO]

Added a few things:
Apex Autolynx
MetalCloak tie rod/drag link: ended up reinstalling my Bilstein dual stabilizer setup as the rock sport stabilizer allowed for too much bump steer
JCR half rack: scored for $200 on FB marketplace
Mopar performance rock rails: scored for $200 on fb marketplace. Had a couple marks but used some krylon textured black spray paint. Perfect match.
Tactik 7” light bar: relocated to my bed rack

Great upgrades for great prices.

Sponsored