Who has Molle Panels in their Bed (Photos)

[813 Fabrication & Design]

Great idea and fabrication, can we install an extra battery inside the bedside enclosure?

there Is only about 8” inside for width so not sure

Sponsored

 

[Stsdroog]

there Is only about 8” inside for width so not sure

Hey Jeremy,
Have you tested to see if Maxtrax mkii fit on the cab side panel. Your kit looks nice BTW. Looking to pull the trigger on a full bed coverage.

 

[813 Fabrication & Design]

Hey Jeremy,
Have you tested to see if Maxtrax mkii fit on the cab side panel. Your kit looks nice BTW. Looking to pull the trigger on a full bed coverage.

I will test again later today to see what it looks like. The MKII are a bit long. When I last tested it, it seems it may stand a little tall for a bed cover if mounted on the Cab Side. They work great on the tailgate.

 

[Mayhem 6]

Easy, quick, clean install! Fit the 3-gal Rotopax perfect. Also, nicely compatible with the Artec crossbars...rest right on top of the MOLLE panel and lines up with cargo rail perfect.

 

[813 Fabrication & Design]

Easy, quick, clean install! Fit the 3-gal Rotopax perfect. Also, nicely compatible with the Artec crossbars...rest right on top of the MOLLE panel and lines up with cargo rail perfect.

Nice, fits in with your set up very well! I just received new plates that are now powder coated. Apologies, I wish I would have had those when I sent these. But, they can't be seen so that's a bonus! Thanks for the order!

 

[Mayhem 6]

Nice, fits in with your set up very well! I just received new plates that are now powder coated. Apologies, I wish I would have had those when I sent these. But, they can't be seen so that's a bonus! Thanks for the order!

Kinda like the raw aluminum on the plates...

 

[813 Fabrication & Design]

Kinda like the raw aluminum on the plates...

Haha, cool, I do as well!

 

[RalphTuttle]

These are the JCR Molle Panels for the Gladiator. I had put the side panels on a couple of weeks ago and liked the fit so I ordered the front bed panel. It arrived yesterday and today I put it on. I will probably trim my rubber bed mat a little so it fits better around the panels.

 

[trust]

I installed the RC panels zbout a year ago. Easy install but did have to figure out a new tonneau latch. I'm thinking about taking them out and installing z used decked set up

 

[trust]

Maybe so, I don't recall the make of mine but there aren't alot of variations. I was thinking about going to a diamond back but now I'm not sure what I'm doing

 

[mrmo]

I have a motobilt molle panel in the passenger rear. It’s super solid 3/8 steel if i remember correctly. I did end up drilling one hole through the wheel well for extra rigidity though the bottom mounting points are optional.
Old pic before anything got mounted.

Holeee shit...3/8"? Just a tad over kill

 

[813 Fabrication & Design]

Holeee shit...3/8"? Just a tad over kill

Their panels are 11ga (.120) steel, a little less than 1/8"

Sponsored