Lots of winch install videos on YouTube that show a pathway for the wires.About to install my warn winch and MOPAR LED 7 inch lights on my factory steel bumper. If anyone has any pictures of how they wired their winch and or grille lights that would be extremely helpful!
This video was very helpful. When you remove the fender, is there anything to unclip that powers the lights? It just looked like he pulled it off after unbolting it.I used the fender removal method shown in this video around the 5:40 mark. Was pretty good. Broke a couple of the clips that hold the fender on during removal. But a 25 pack of them is $8.
25PCS Fender Flare Clips, Rocker Moulding Retainer Clip 68039280-AA Replacement for Jeep Wrangler JK & Unlimited JK 2007-2018, Ram 4500 2011-2017, Ram 5500 2011-2017 Chrysler 55157055-AA, 55157065-AA https://a.co/d/caQ5rsk
On the passenger side where the bumper meets the frame rail, you should see a grey connector. That connector is for the fog lights. That is the only electrical connector you need to disconnect.This video was very helpful. When you remove the fender, is there anything to unclip that powers the lights? It just looked like he pulled it off after unbolting it.