djdannis
Member
- Thread starter
- #1
I’m reading several posts on the P00AF code which I got twice when visiting out West on a recent trip not pulling anything, just roof top tent under 65 mph. Some folks say a new turbo is in order because of something with the actuator.
Since this code only pops in very specific circumstances, has anyone fully confirmed their issue as resolved? Since I live in Iowa, I know of no way to recreate the issue to confirm if I get it done. If the turbo has to be replaced and the cab removed, it will be a significant job as I have a lot of wiring and tubing running between frame and body for my overlanding setup.
Hence why I’m seeking a final consensus from those that have gone through this. Does it work and have you put the truck through it paces in the same scenarios after the turbo was replaced?
I also have an EOC stage 1 tune and EOC just says the turbo is fine, I’m just pushing the truck too hard. I understand the weaknesses of the Ecodiesel with heat, etc so I do my best to make sure the truck isn’t pulling hard and within nominal temps.
Since this code only pops in very specific circumstances, has anyone fully confirmed their issue as resolved? Since I live in Iowa, I know of no way to recreate the issue to confirm if I get it done. If the turbo has to be replaced and the cab removed, it will be a significant job as I have a lot of wiring and tubing running between frame and body for my overlanding setup.
Hence why I’m seeking a final consensus from those that have gone through this. Does it work and have you put the truck through it paces in the same scenarios after the turbo was replaced?
I also have an EOC stage 1 tune and EOC just says the turbo is fine, I’m just pushing the truck too hard. I understand the weaknesses of the Ecodiesel with heat, etc so I do my best to make sure the truck isn’t pulling hard and within nominal temps.
Sponsored
Last edited: