Your first Mod of 2025 was (or will be)?

[domanator1]

Mod 1 of the year is replacing my 20 with a 24. Mod 2 thru 5 will depend on what order the parts show up.

Sponsored

 

[HydroPearl]

Have some tailgate lettering and badging coming from @GladiusOffroad

Nice! Me too!! I did a fully custom one.

 

[SaiintNick]

Mod 2: HotHead Headliners
Mod 3: Off Roam phone holder. I usually go with 67 Designs, but wanted to try something different.
Mod 4: Armorlite flooring
Mod 5: Sound deadening the floor and back wall.

 

[Dawgfan89]

Very close to finishing the fender chop project - put on a set of Rubicon takeoffs from FB marketplace I found last fall. A friend helped me repair a couple of bad gouges and I repainted them. Installed the Inifinite Offroad fender chop kit and the Combat Offroad inner fender liners after painting the accent panel. I will have to trim them because my Apex sway bar disconnects are rubbing a little bit - hope to get that done within a week or so. I haven’t decided yet if I am going to chop the rear fenders.

 

[SamO.5]

Installed a power outlet with a lid, on top of the dash, in the dash tray. It is wired to the same outlet as the smartphone interface. Also installed an aluminum mount base with a 1" ball compatible to RAM mounts, so I can use the long double socket arm and the X-Grip. I now have no wires dangling from the cell phone.
Also, will be installing my two 7 Inch Spot Flood Combo LED Lights on Exceed Fabrication's Cowl Light Bracket, next to the existing pod lights that I will move over to this new brackets lower level.
Am currently recuperating from knee surgery, and I'm on my employers short term disability payments (¢¢¢), or I would be purchasing Warns winch mount plate for my two month old Badlands winch, that is still in the box, which I am itching to install inside the Rubicon's factory steel bumper (I couldn't get to it before surgery).
Then, after I go back to work: the Diamondback SE, with their Front Runner + Rack System.

 

[Jaydebe]

I’m getting new drop side steps (Christmas gift from wife). Currently have the OEM Overland runners, going to be the second mod, other than wheels and tires, the only other mod was a smart cap with solid side with Molle inside doors.

Question for you about SmartCap.
I can't find on the website the height of the cap?
Would you be willing to measure the opening size, Tail gate down to cap door open and a second measurement from bed to top inside of cap?

I'm trying to see if I'd be able to store 2 mountain bikes upright w/front tire removed.
When I build a van, I needed 37.7" clearance to slide the bikes in and out.

If you don't have time, no problem, if you do, huge Thx ahead of time!

Jay

 

[booneja]

Ok, opening height is 34”. Inside height is 39” but there are inner struts that drop down 1”. Hope that helps

 

[jav_eee]

If I mail a letter in Edinburgh Texas, to my home address 10 miles away, it'll go to Little Rock Arkansas first. That's the efficiency of USPS hubs.
GladiusOffroad has awesome stuff, I just put on tailgate lettering today.

Puro 956ALV

 

[cnoble]

Did a winch though I'll never probably use it. Had a plate from my aftermarket oem style front bumper.

Where did you get your bumper? Looks great.

 

[Mightytalldude]

Puro 956ALV

Where's places to wheel around here, besides North end of South Padre Island?

 

[jav_eee]

Where's places to wheel around here, besides North end of South Padre Island?

MARS off road park in linn-San Manuel. There are a couple of clubs who get together and go wheeling at different spots too. A popular one is STXoverland

 

[Mightytalldude]

MARS off road park in linn-San Manuel. There are a could have clubs who get together and go wheeling at different spots too. A popular one is STXoverland

Thanks! Normally I would say you can't miss me when it comes to my JT, but I've never expected the valley to have a couple thousand JT's driving around.

 

[Minty JL]

Well DV8 send my door pockets in 2 separate packages.......one arrives tomorrow and the other on Friday.

 

[Mr.Wilson]

Rigging out my roof rack with extra fuel cans and storage containers.

What brand is your roof rack?

 

[Jaydebe]

Admittedly not the best pic; but since it's 9* before windchill today, my crusty JT wasn't going to be looking her finest anyhow.

Installed some factory (dealership removed) LED headlamps and added a JLTazer to make them work!


Rims on the way!

Sponsored