What did you do TO your Gladiator today? [ADMIN WARNING: NO POLITICS, NO GUN TALK]

[Markpod7]

installed a JK taktik over rider bar! Little fabrication but came out awesome!

Sponsored

 

[Pizziola29]

Added a KC Chase Light bar with flashing ambers behind the glass.

 

[Steelers11]

I got mine in the mail yesterday... Looks like a bit more of an install process than on the old wrangler... Probably next weekend for the install. Looks great.

@Tobbun just as easy as on the wrangler

 

[mjoneil]

added some KC gravity pros (2 wide, 1 spot) and KC Flex on the Gatekeeper offroad knuckle mounts.

 

[mx5red]

added some KC gravity pros (2 wide, 1 spot) and KC Flex on the Gatekeeper offroad knuckle mounts.

I was set to order these, but thought the lights would be blocked by the bumper.
Can you show a picture of them on? Does the bumper block much?
Are you at stock Rubicon height?

 

[Steelers11]

@77badriand I agree 110%. White underneath is ugly

 

[mjoneil]

I was set to order these, but thought the lights would be blocked by the bumper.
Can you show a picture of them on? Does the bumper block much?
Are you at stock Rubicon height?

I have a 3.5 lift with 38s - there is some blockage but once you turn the wheel, its going to have close to 100% light output.

Also I have a sport so maybe with the rubicon you will be better off bc of wider axles?

 

[Deleted member 30519]

I have a 3.5 lift with 38s - there is some blockage but once you turn the wheel, its going to have close to 100% light output.

Also I have a sport so maybe with the rubicon you will be better off bc of wider axles?

Im supposed to be getting my 38" patagonias mounted to my -12mm 4.5 backspacing wheels on Sunday. I have a sport with 3.5" coil lift. You guys think I'll be good for a full lock ?

 

[Stitchedupseats]

Got the rubigrid installed. Hope it holds up. Good fit.

 

[kaeo_15]

@Gren71 Bruh. Found some Frost King gasket material I had lying around when I weatherproofed my Plano Boxes. Put some in the cowl and ran a strip up the side of the door frame like you did. Whistle and wind noise I had is COMPLETELY gone. I need to find something more permanent for the door frame but, damn, I am hella impressed. Thanks again.

 

[danimalco]

Added a Barricade Extreme full width front bumper. Next will be rock slider/steps the wife and granddaughters say they need them to get in. Wife has approved of the purchase.

I think i'm going to order the Barricade Rock Sliders tonight. Looks like a cheaper alternative to the ACE sliders, and I'm hoping to keep my factory sliders on. What do you think of the build quality on the bumper? Good welds/paint holding up?

 

[Garemlin]

Installed the Go Rhino RB20s. Install took a little longer than I had hoped. They replaced old hardware with new hardware that wasn't documented in the instructions. Thought I was missing some and had a bunch of extras. LOL

 

[doc-ketamine]

My MetalCloak 3.5” GameChanger with replacement front drove shaft and RockSport shocks is now installed! Gladys is very tall and my wheel wells are way too roomy. Was gonna go with 35” Toyos but I think I need to look for 37s ...

Just some quick snaps from picking her up, will try to get better pics this weekend.

 

[CoWhiteGladiator]

Thanks. I am planning on installing lights and chopping, and like the idea of removing the plastic trim. Is the metal edge under that trim a "clean" line? Assume you like the look? Any regrets on the removal of the trim? Did you do the rears too?

It’s not metal it’s all plastic and it was a clean line but it has like these little plastic things that hang down thwt i took a razor blade too and i cut them off. And i have no regrets from doing it i love the look and it works great!

 

[mx5red]

I have a 3.5 lift with 38s - there is some blockage but once you turn the wheel, its going to have close to 100% light output.

Also I have a sport so maybe with the rubicon you will be better off bc of wider axles?

Thank you very much.. I’m stock so not sure I’d get much light through..
Thinking of fab’ing my own that put the light lower down by the tie rod

Sponsored