What did you do TO your Gladiator today? [ADMIN WARNING: NO POLITICS, NO GUN TALK]

[cpearce]

Installed a Forward Trail Cam

I was afraid the BOLT Hood Lock would get in the way but the camera fit perfectly.

Did this create any other electrical issues?

Sponsored

 

[XraytecH]

Did this create any other electrical issues?

Nope, clean factory looking install.

 

[cpearce]

Nope, clean factory looking install.

My dealer doesn’t want to install saying it will create other electrical problems. Might have to check another dealer. Thanks.

 

[Sespe]

Installed an Under The Sun insert. It looked too open with the honeycomb black parts taken out so I replaced them and now you couldn't make out the olive drab flag. Fortunately I got it double sided (with one side in black just in case), so just flipped it and replaced the OEM black grill. Not a bit noticeable unless you're up close, but I'm happy with it.

So, I think my insert is not visible enough with the honeycomb insert. Is it easy to take the honeycomb out? Will the insert still sit snug?

 

[Kevin_D]

Flipped over 15,000 miles this afternoon!

Kevin

 

[garzilla]

We BOUGHT it!!!

 

[Yossarian]

We BOUGHT it!!!

I have a T Shirt exactly like yours. My Jeep? Doesn’t match.

 

[Blade1668]

Here ya go brother, clean up those cut edges with this.

Edge Trim Black Large, Fits Edge 1/4 Inch, Length 10 Feet (3.05 Meter) https://www.amazon.com/dp/B00KGAKG2...abc_AKSC42SY5ZZQ539MBZPB?_encoding=UTF8&psc=1

I installed the Rubicon bed sliders last year and used that kind of trim to neaten up the lines where you have to cut the bumper to make them fit. now it looks way better with the trim in place.

It came with 2 strips to do it with. The part where I commented on not following the instructions is I only needed to notch out a spot on bumper. It might be a slight change on it or that I'm mounting lower.

 

[Blue Ridge]

So, I think my insert is not visible enough with the honeycomb insert. Is it easy to take the honeycomb out? Will the insert still sit snug?

Yeah, just some tabs need pulled. Skip to 1:25 in the video.

 

[Bkinnell]

Dropped my windshield today so I could install some a-pillar mounts and light bars. Also mounted my traction boards.

Where did you get that rack across the cover? Brand?

 

[Bbannongmu]

Got aligned after Rusty’s 2”lift Also saw this J10 at the shop!

 

[Ridgeline]

Where did you get that rack across the cover? Brand?

That would be the KB Voodoo crossbar: https://www.kbvoodoo.com/shop/jeep-gladiator-hi-rise-crossbars-for-use-with-tonneau-covers

 

[Sportsbiz]

Installed my Yaesu 400 ham radio with the control unit attached to grab handle with CMM Offroad and 67 Design components.

 

[am1978]

Checked the VIN/Window sticker status—nothing yet, D1 though. Ordered a Rugged Ridge retractable tonneau (ships next week), a Quadratec dead pedal with pad (back ordered until June), Quadratec/WeatherTech floor mats, and some Quadratec step bars. Selling my JL stuff and setting the JL back as close to factory before I offload it.

 

[Tmtmtl666]

Installed Rock Hard 4x4 down angle sliders.

Sponsored