Northridge4x4
Summit Sponsor (Level 3)
- Joined
- Feb 27, 2017
- Threads
- 112
- Messages
- 586
- Reaction score
- 1,020
- Location
- Silverdale, WA
- Website
- www.northridge4x4.com
- Vehicle(s)
- 2016 Sahara JKU, 2013 Rubicon JKU
- Occupation
- Seller of badassery
- Thread starter
- #1
One more Hemi going into a Gladiator, this time around it's a 6.4 Hemi.
485hp+ and 475 ft-lbs of torque, the 6.4 Hemi will make a Gladiator move fast.
Any build has to start somewhere and we're going to start with the grille.
Then start tearing it all down until you can pull the cab off.
Then it's time to start disconnecting everything on the not-so-old engine to get it ready to pull.
Roll the chassis out the door, grab the forklift and pull the stocker 3.6 out. All the while trying not to breathe in the smoke hanging in the air.
Every wonder what the underside of a new cab looks like? This Gladiator had less that 1600 miles on it.
Next up is to pull the stock Rubicon transfer case off the back of the old 8 speed trans.
Then bolt it to the new 8 speed behind the Hemi.
While that is happening, head mechanic Jeremy has cut the OE engine mounts off the frame and is sanding the frame down smooth.
Then I stepped away for 30 seconds and he had the new Hemi mounts welded in!
More pics to come as the mechanics make progress....
485hp+ and 475 ft-lbs of torque, the 6.4 Hemi will make a Gladiator move fast.
Any build has to start somewhere and we're going to start with the grille.
Then start tearing it all down until you can pull the cab off.
Then it's time to start disconnecting everything on the not-so-old engine to get it ready to pull.
Roll the chassis out the door, grab the forklift and pull the stocker 3.6 out. All the while trying not to breathe in the smoke hanging in the air.
Every wonder what the underside of a new cab looks like? This Gladiator had less that 1600 miles on it.
Next up is to pull the stock Rubicon transfer case off the back of the old 8 speed trans.
Then bolt it to the new 8 speed behind the Hemi.
While that is happening, head mechanic Jeremy has cut the OE engine mounts off the frame and is sanding the frame down smooth.
Then I stepped away for 30 seconds and he had the new Hemi mounts welded in!
More pics to come as the mechanics make progress....
Sponsored
Last edited: