Looking for 8 pin connector - 115v bed outlet

[Dunks001]

I’ve been patiently waiting for 6NU24TX7AB Headlamp Switch Bezel to complete the 115v AC truck bed power switch. It’s been four months and still no word on when the switch bezel will be available. I’m prepared to relocate the inverter switch (68370049AA) but I’m hesitant to cut and solder an extension. Does anyone know where I can buy a matching 8 pin connector? Thx ?

Sponsored

 

[Lost1wing]

I am in the same position waiting for the bezel. The connector is definitely something I could use. If I am unable to get the bezel. I would go with a larger inverter and it's own battery. I have another aux switch to turn the inverter on when needed and 12v at the bed to charge the battery.

Are you still planning on using the existing inverter and adding a different switch?

 

[Dunks001]

I already have the OEM switch and planning on keeping the stock inverter for now. I'd like to have separate power in the trunk bed with a battery, inverter, BCDC, solar... to run all lights and accessories from.
My bezel already has a hole where a switch used to be before getting an sPOD switch. Planning on making that hole a bit bigger and putting the OEM inverter switch in there.
Hopefully today I'll cut and solder to extend the switch. Attached is the pin information for the switch. *I've given up on finding a matching connector.

 

[dcmdon]

Have you tried looking on ebay for the bezel. I"ve found stuff that is perpetually backordered on ebay.

 

[Dunks001]

Have you tried looking on ebay for the bezel. I"ve found stuff that is perpetually backordered on ebay.

Good idea. Just tried and couldn’t find the part number 6NU24TX7AB.

 

[ShadowsPapa]

are there any numbers on that connector? I've been looking through a lot of resources lately to buy some of the special connectors needed for my restorations and while looking, I see things that look similar to yours here and there. Often there are numbers on the connector shells (the plastic part of the connector the pins go into)

 

[Dunks001]

Thx for trying. Only a 8 on the face of the connector.
Missed out going to the Moore Overland Expo this weekend. I had motivation to cut and solder on an extension today. It works!

 

[ivanfrank]

Someone is currently selling all these parts in the member marketplace, might be able to hit them up

 

[Luis guido]

Hello,
I have a Rubicon 2022 that came without power bed (Windows sticker states: 115vts power bed delete credit - $ 45).
I assumed the converter is the one I can see installed below the driving column (68530204AB), therefore I have installed the parts needed to add power to the bed (headlamp switch bezel 6NU24TX7AB, inverter switch 68370049AA, Jumper wiring 68398209AB, Inverter power outlet 68312754AC).
The issue is: the dashboard harness which has the lights command plug, doesn't have pigtail with a plug to be connected to Inverter switch when added below the light command (that pigtail should come taped to the lights command wiring)
I went to the dealer and they said my Jeep came with harness 68525802AC, and in order to have the missing wire and plug, I should have the Harness 68525802AD
The missing plus is 3 wires plug, so I assume it is just an ON/OFF switch
Anybody knows where do I get the power and what should I feed in order to run a line to add the missing circuit?

Sponsored