What did you do TO your Gladiator today? [ADMIN WARNING: NO POLITICS, NO GUN TALK]

[JRobes]

Been fighting a balance issue since I bought these tires and wheels used. Well last weekend I heard what I thought was beads in conjunction with the wheel weights. Pulled the weights, slightly better. Ordered new beads and went to put the in today. But first vacuum out the old I figured…. It’s a mix of sand and what looks like melted rubber (not tire rubber). No idea what it is. Hopefully better with some actual beads.

"Shoot, you don't need to spend no money on no balance beads, here's a handful of asphalt aggregate!"

Sponsored

 

[mx5red]

"Shoot, you don't need to spend no money on no balance beads, here's a handful of asphalt aggregate!"

I usually just use coffee grounds, plenty cheap?‍

 

[NewSlant]

Picked up from Gupton on 10/29. They were fantastic up there. Quick and painless process getting the jeep. Been a busy few days but, since then I have put on a stubby antenna and some rock rails off a rubicon. Up next is setting up the Jscan and putting my rubicon take off wheels and tires on. As well as LED headlight replacement and some other small cosmetic stuff. Thanks to everyone on this forum I have learned a ton!

 

[Kyle10]

6” Rough Country lightbar on DV8 bed rack.

 

[SubiRubi]

RPM Aluminum Steering upgrade..

 

[antwon412]

Replaced my stock track bar with a Metalcloak adjustable.
After the AEV lift my front axle was off center.

 

[Kentuckyarms]

Hmmm, I like that setup. When I get my TF 1.5" installed, may have to go with those tires, I'd like to keep MT's and go just a bit bigger. You like them?

I have no complaints about them.

 

[sep]

New bumper and winch.

Very happy with the install and final result.

 

[Jorgeperezjr]

813 Underhood ARB Compressor Mount plus Synergy track bar and sector brace. Big difference in steering afterwards ?

 

[mx5red]

RPM Aluminum Steering upgrade..

I can’t tell, how is your steering stabilizer connected? It’s some kind of relocation, right? Looks too high to be stock

 

[Kyle10]

80 in NJ today. Took the doors off !

 

[SubiRubi]

I can’t tell, how is your steering stabilizer connected? It’s some kind of relocation, right? Looks too high to be stock

It's in the stock location on the tie rod side.. The mount on the axle side is Falcon tho which makes it higher than stock

 

[ecidiego]

Well it's been one year and I finally took the doors off. I bought the Go Without Doors cart about 9 months ago, lol. Also added Delrin hinge bushings and door pins. I like this set...the top is longer to make it easy to align them. Thanks again @Gren71 for the lead.

 

[Vanishing Point]

Added to my sticker collection.


Also went ahead and put an edge on the board that I'm going to mount to the tailgate so I can mount some tools there within easy reach.

 

[Hockeydad55]

New lift,wheels and tires

Sponsored