What did you do TO your Gladiator today? [ADMIN WARNING: NO POLITICS, NO GUN TALK]

[4wheelgobbler]

Would you mind measuring the overall width? Also how does it mount to the brackets?

Looking to find one I can bolt to the WJ2.

here you go! There is also a bolt that goes up through the bottom of the bracket into the bar to mount it.

Sponsored

 

[XJFanatic]

Thanks that looks like it would work perfectly and only requires me to drill two holes in the bumper.

 

[19Comanche86]

Mopar bumper, skid plate and filler panel just got delivered. My wife was cursing me after she had to drag it in to the garage ?

just waiting for my Maximus 3 XLP hoop and that will be it for the front end.

 

[XraytecH]

[

Rookie question. Can you tell me how the disconnects work. Do you just turn the top part to disconnect/connect the sway bar? I need to do something for my JT. The rock jock setup looks to be the best option and the most expensive. These look more promising.
Have you put these to the test yet? Do you like them?

Kinda hard to see but here they are flexing…

 

[Puch]

Kinda hard to see but here they are flexing…

I think I’m sold.

 

[Koaloha]

Quadratec Dead Pedal. Definitely a higher Quality vs Amazon stuff

 

[1JeepFamily]

Quadratec Dead Pedal. Definitely a higher Quality vs Amazon stuff

Nice install.

No sarcasm: in what situation would you want the dead pedal in the upright position? Looks like it'd nail you right in the shins.

 

[19Comanche86]

Installed my Mopar steel bumper and skid plate today. Waiting for my Maximus 3 xlp hoop still. The Mopar one will do for now.

next up, steel rear bumper and that’s it for a while

 

[Blue Ridge]

Nice install.

No sarcasm: in what situation would you want the dead pedal in the upright position? Looks like it'd nail you right in the shins.

Not who you asked, but QT dead pedal owner here. Once in a while you just need to stretch and point your toes downward. Overall, a dead pedal makes for a much nicer experience on long drives, but you just need to change positions every so often. That said, it's been so long that I flipped mine up that I forgot you could until this thread reminded me!

 

[Gren71]

Clayton offroad rear LCAs set them to 24in on center of the bolt holes.

also installed the quadratec 2in receiver and wiring harness in my wife’s JLU. And the AEV steering stabilizer

 

[NotSo Bright White]

Nice install.

No sarcasm: in what situation would you want the dead pedal in the upright position? Looks like it'd nail you right in the shins.

To remove the floor mat.

 

[TheSolarWizard]

is this an easy install? Someone a while back posted about xyz brand being a royal pita to install

Quadratec Dead Pedal. Definitely a higher Quality vs Amazon stuff

 

[PrisonMike]

Added a Sunrider!

 

[Blue Ridge]

is this an easy install? Someone a while back posted about xyz brand being a royal pita to install

The good news is, there's only one bolt. The bad news is, that one bolt is on tighter than you'd believe and it's hard to get much leverage down there.

 

[sass JT]

Just threw on a drt fabrication hitch skid.

Sponsored