What did you do TO your Gladiator today? [ADMIN WARNING: NO POLITICS, NO GUN TALK]

[J3colt]

Today I added a Factor 55 Prolink in gray to my Superwinch. It's definitely well engineered and a quality bit of kit. Much quieter than an old school hook. I will say it looks a little odd and sticks out farther than expected...looks like the jeep has a pacifier in its mouth. ???

Sponsored

 

[TexasCajun]

Installed the bestop sunrider.

 

[sass JT]

Today I added a Factor 55 Prolink in gray to my Superwinch. It's definitely well engineered and a quality bit of kit. Much quieter than an old school hook. I will say it looks a little odd and sticks out farther than expected...looks like the jeep has a pacifier in its mouth. ???

I had a red one on previous build… it got called a nipple a lot lmao!

 

[BaliMawr]

Firestone Airbags.
Link to Build Page

 

[Ar4130]

Added some lockable storage under the seat. Super easy and cost me nothing, as I had an extra gun box laying around.

 

[-miko-]

Took time to do a good spring detail before pollen season sets in. I’ve amassed quite a collection of products thanks to folks here. Not sure whether to thank you all or curse you ?

 

[BaliMawr]

Took time to do a good spring detail before pollen season sets in. I’ve amassed quite a collection of products thanks to folks here. Not sure whether to thank you all or curse you ?

Oh, Good stuff- I need to do that!

 

[JT Thomas]

Put my rugged ridge HD full width bumpers and a stealth 10k and added the badge glow Aux plate to clean up my wiring. Going to add 6 inch KCs to the over rider bar next week if weather cooperates.

 

[polarisTXguy]

Well not today but finally got around to mounting my ARB compressor. Used the ACM Mount and heat shield. Wired into the factory aux switches and ran the chuck to the front frame behind the bumper

yep I used red electrical tape, couldn’t find my roll of black.

 

[MattHamilton]

I installed the Voswitch JL300. And I've never before removed a piece of trim on any vehicle I've ever owned. Took me 2.5 hours (I gave up on the grommet in the firewall after about 20 minutes and ran the control wire through the windshield instead). I haven't plugged anything into the control unit yet, but I will.

 

[chorky]

Well not today but finally got around to mounting my ARB compressor. Used the ACM Mount and heat shield. Wired into the factory aux switches and ran the chuck to the front frame behind the bumper

yep I used red electrical tape, couldn’t find my roll of black.

You mean to say you have the factory aux switch activate a relay for the compressor...right? Those things pull a lot of amps

 

[JTzntz]

Worked on my GMRS radio install. KG-1000G chassis mounted under steering wheel where factory 110V inverter would go, and control panel remotely mounted overhead.

hopefully finish wiring next weekend.

 

[polarisTXguy]

You mean to say you have the factory aux switch activate a relay for the compressor...right? Those things pull a lot of amps

Correct. Main hot directly to the battery and relay activated by switch one on the factory aux panel. Well with in spec for current draw

 

[Dougstdig]

Worked on my CB & GMRS install. Also took some photos of the impact areas where my front end is bottoming out. Oh yeah, my buddy pointed out to me I have an antifreeze leak…?. No idea where it’s coming from.

 

[ArmyMP]

Lamented the loss of my radio. It's toast from a baf OTA update.

New ones on its way somewhere.

Sponsored