Mojave on 37s, flat fenders and no lift, thoughts?

[BigM]

I have a 2020 Mojave Gladiator and I want to run 37 inch Nitto Ridge Grapplers on the stock suspension and no lift. I plan to regear and install Road Armor fender flares front and back for added clearance. I'm also adding a Fishbone stubby front bumper with no winch. Do you think this combination would work without rubbing. Thanks in advance.

Sponsored

 

[Bbannongmu]

Running 37s on my Rubi with 1.5” leveling puck. Seems like Mojave would be about the same size.

 

[BigM]

Running 37s on my Rubi with 1.5” leveling puck. Seems like Mojave would be about the same size.

Great video and thanks, did you resolve the issue with the rub when it was turned to the left?

 

[Bbannongmu]

Great video and thanks, did you resolve the issue with the rub when it was turned to the left?

Yes. All good.

 

[BigM]

Yes. All good.

Outstanding, great information and quick easy low cost fixes are always welcome. No concerns with the front sway bar disconnect as the Mojave does not have one so I believe I should be fine. Again thanks!

 

[Mtpisgah]

Yes. All good.

Have you tested it off-road to see how much it rubs?

 

[SloW8]

The Mojave rides an inch higher in front than the Rubi from the factory. I am seriously thinking of jumping to 37" BFGs, which run a little small, and doing fender brace/liner removal kit from AAL. If that doesn't work I would add a 1" spacer kit all around.

 

[JfishKing]

The Mojave rides an inch higher in front than the Rubi from the factory. I am seriously thinking of jumping to 37" BFGs, which run a little small, and doing fender brace/liner removal kit from AAL. If that doesn't work I would add a 1" spacer kit all around.

would you be doing any off roading? i am in similar predicament as you are... just dont have the jeep yet... lol

 

[JfishKing]

I have a 2020 Mojave Gladiator and I want to run 37 inch Nitto Ridge Grapplers on the stock suspension and no lift. I plan to regear and install Road Armor fender flares front and back for added clearance. I'm also adding a Fishbone stubby front bumper with no winch. Do you think this combination would work without rubbing. Thanks in advance.

very interested in this... let me know what you end up doing.

 

[itsdapk]

Stock height, 37/1350/20s , All Rugged Ridge flares,liners, bumpers, winch.

 

[gr82bagn]

Looks great! Looks like plenty of clearance for those of us not doing any rock crawling. Any rubbing at full turn? Stock gears?

 

[itsdapk]

Looks great! Looks like plenty of clearance for those of us not doing any rock crawling. Any rubbing at full turn? Stock gears?

No rubbing at all even over high speed bumps. Y
I have 5.13s and a Hamburger's Supercharger.

 

[JBRLLC]

37s are no problem. I've tried hard to make them rub and haven't been able to yet. These are 12.5 wide and -18 wheel offset.

 

[MoparToYou]

I have a 2020 Mojave Gladiator and I want to run 37 inch Nitto Ridge Grapplers on the stock suspension and no lift. I plan to regear and install Road Armor fender flares front and back for added clearance. I'm also adding a Fishbone stubby front bumper with no winch. Do you think this combination would work without rubbing. Thanks in advance.

Yes

 

[JfishKing]

37s are no problem. I've tried hard to make them rub and haven't been able to yet. These are 12.5 wide and -18 wheel offset.

Looks great I am looking. Black rhinos -18 and 37 ridge grapplers. What size wheels are those 17x9? Also can you put up some pictures looking at on high see how much poke there is. Thanks.

Sponsored