Aftermarket Aux Switches (satisfied Voswitch customer)

[dos0711]

Another satisfied Voswitch customer…

Sponsored

 

[Kyle10]

I just put same in on Saturday. Very easy maybe 30 min. And seem to work well so far

 

[JeepOfTheseus]

I have the center dash mounted panel. High quality stuff, very happy with it.

 

[Medical_Bartender]

I ordered the same product last week and it'll be delivered this thursday. Glad to hear so many positive reviews about it. I'm thinking i'll put all my lights on the A-pillar switches and then use the factory aux switches down below for not lights.

 

[rr11]

I also have the console mounted switches. I installed them in 2020 and I am still happy with them.

 

[Rainman519]

OP - strongly looking at this, can you provide some more info (possibly pics) of installation? Curious regarding the connection module under the hood. Thanks.

 

[dos0711]

Here are the instructions

OP - strongly looking at this, can you provide some more info (possibly pics) of installation? Curious regarding the connection module under the hood. Thanks.

I didn’t take pictures. The instructions are on the Amazon page. The only thing I didn’t do was lower my windshield. I took the wire through the clutch block off plug. It’s a simple process.

 

[drewcnit]

OP - strongly looking at this, can you provide some more info (possibly pics) of installation? Curious regarding the connection module under the hood. Thanks.

Blurry pic but I have the 8 switch on the A pillar. Don't have any pics of my install either but it was a lot easier than I expected.
What specifically were you trying to see under the hood?
I'll see if I can grab some pictures under there later today.

 

[Rainman519]

Thanks Drewcnit. Just curious how everything is powered (battery connection) and module where aux lights etc connect.

 

[DCPHOENIX]

I’ve been waiting until pay day to order one of these!
Looks so neat up there. Way better then a big chunk sat on the dash (in my opinion)

 

[Bobchadwickga]

I installed the VOS switches that go into the stock position. This is out of the way and I don't have to worry about impacting a set of switches installed in the pull. If I eventually need more than the six switches, I can always add the set that goes into the pillar.

 

[dos0711]

Some pics…one small wire to inside the truck

 

[Rainman519]

That's what I was waiting to see. Doesn't look to intimidating of an install. Thanks Dos0711.

 

[rr11]

The install was easer than I expected. And I have the ones that go in the stock position. my only complaint is no ejection seat sticker to place on a unused switch.

 

[mikeviv18]

I have the center dash mounted panel. High quality stuff, very happy with it.

Do you have pictures of the center dash mount?

Sponsored