What did you do TO your Gladiator today? [ADMIN WARNING: NO POLITICS, NO GUN TALK]

[Soedog]

Installed the Mopar Hard Tri Fold Bed Cover. Mostly happy with the result but aligning side to side and front to back would have been easier without the trail rail system. Had a similar Mopar version on my Ram. Love the low profile under the rail look and the added security of a hard cover.

Sponsored

 

[TheWingman]

Added some much needed tie downs up top. No trail rails here...

 

[TTEChris]

Pulled my stock axles.

 

[bhbdvm]

You got any info on that plug? One of the few upgrades that wasn't on my Overland.

Here is a link.
https://www.dometic.com/en-us/us/pr...e/coolers/accessories/dometic-hwk-dc-_-222471

 

[Markpod7]

Just a little TLC.

 

[SleepyJeep]

Installed the CB Bar and Cobra CB 79 Max CB radio, as well as the AVS bug deflector with lightshield.

 

[Keller]

Installed Tyger Tonneau Cover

Also put a 6 inch Stubby antenna on.

The Tyger took about 20 minutes including unboxing.
Quality, I’d give an 8/10
Install Ease 10/10
Value 9/10

It’s nice that you can take it off in about 2 minutes if you need to haul something large.

 

[smlobx]

Installed Tyger Tonneau Cover

Also put a 6 inch Stubby antenna on.

The Tyger took about 20 minutes including unboxing.
Quality, I’d give an 8/10
Install Ease 10/10
Value 9/10

It’s nice that you can take it off in about 2 minutes if you need to haul something large.

I see what you have tucked back in there....

 

[Keller]

19 Miami Blue TTS
I see you have something similar

 

[OrangeChuck]

Installed the CB Bar and Cobra CB 79 Max CB radio, as well as the AVS bug deflector with lightshield.

I thought the grille insert was supposed to replace the honeycomb. Did you have difficulty installing the flag insert?

 

[MoparDave]

Installed WARN Mid Grille Guard Tube

View attachment 54204

 

[SleepyJeep]

I thought the grille insert was supposed to replace the honeycomb. Did you have difficulty installing the flag insert?

No, the grille insert goes behind it. No trouble installing it, just a bit of elbow grease with those push pins to remove the grill and you have to snap it shut, but not difficult. Should take you no more than 30 mins.

 

[steffen707]

from Tom Winkels.

i got our pacifica warranty from him.

 

[Gladiation]

Make a circuit that uses a relay controlled by the reverse lights that turns off the license plate lights when the vehicle is put into reverse.

Smart, I was just thinking about how annoying those lights are on the camera while backing out

 

[Phinneywood]

Added some much needed tie downs up top. No trail rails here...

Nice, I really need to do this. Do you recall if the screws are M6x30?

Sponsored