which did you go with? If the draw-tite how did it fit/install?Great info! Still trying to decide between the Curt and Draw-Tite. It looks like the Curt is lower profile but the Draw-Tite is stronger. Will probably go with the Curt for better approach angle.
https://www.curtmfg.com/part/31086
https://www.draw-tite.com/product/65079_front-mount-receiver
did you choose the Curt model over the Draw-tite for any reason? in particular was it going to be easier to modify/install than the Draw-tite?I put a Curt front receiver on my Mojave, had to trim the remote shock res. bracket basically cutting off one bolt hole, and had to remove the nutsert for that bolt. Trim the bracket right and it lines up with the curt bracket so the one bolt holding it is solid can’t move as the hitch bracket holds it in place. Putting hitch on was about a ten minute job after that, putting the skid plate on took hours as I trimmed a bit at a time, until just about done I realized you have to cut out a big square and the hitch fits fine, frame of receiver hitch is right up against skidpkate, very solid....Jack
.
I just placed the order for the Curt receiver. I'll upload some pics once it's installed.which did you go with? If the draw-tite how did it fit/install?
Thanks @Jaxmax. Can you explain more about the weld causing corrosion?Unixxx, your done , you did I think the best job, I've seen including mine, DO NOT WELD IT, that will just cause place for corrosion an dproblems if you have to remove hitch, hitting the nuts with black gloss paint is a good idea in the salt belt areas. Nice job!.....Jack