Rockabillyroy
Well-Known Member
Sponsored
The bracket you see in their pics is the one that comes with their inner fenders. I received the same brackets when I did the metalcloak fenders and their inner fenders.So I was not expecting this bracket. In the MetalCloak instructions it looks a whole lot different. So I’m pausing this install till I figure this out.
tagging @Metalcloak here to see if they are aware of the bolt issues and may have any guidance.
OH MY GOD, does anybody read previous posts or maybe the directions!?OK GENTS, so I received my parts with only two bolts am I good to go or do I need any additional bolts and washers ?
2020 rubicon gasser
Read the directions three times read all previous posts ,what I gathered was a different reply from each post nothing clear as a common denominator some were sent with two bolts some with four.What color of pink did you paint yours bright or dull ?OH MY GOD, does anybody read previous posts or maybe the directions!?
Ouch, that hurt!Read the directions three times read all previous posts ,what I gathered was a different reply from each post nothing clear as a common denominator some were sent with two bolts some with four.What color of pink did you paint yours bright or dull ?
Simple question ,did ya catch the tools needed 13mm. ,18 mm .Ouch, that hurt!
Ouch, that hurt!
Ouch, that hurt!
Ouch, that hurt!
If the threaded boss on your frame mounted brackets have fallen off or you plan on drilling them out, then yes, you are good to go.OK GENTS, so I received my parts with only two bolts am I good to go or do I need any additional bolts and washers ?
2020 rubicon gasser
Thank youIf the threaded boss on your frame mounted brackets have fallen off or you plan on drilling them out, then yes, you are good to go.
If not, the you need to buy bolts that are correct size, length and thread pitch.