What did you do TO your Gladiator today? [ADMIN WARNING: NO POLITICS, NO GUN TALK]

[Vtur]

I think it really depends on individual uses and location location location. I already bashed the stock dinky skid plates this past summer, on a very very mild section of trail. But opted for the quadratic skids, which will do a fine job, instead of the other options that were in the 2,000-3,000 dollar range. The interesting thing is, compared to what I see others on here doing, these components are relatively 'cheap' - especially the lift - compared to some folks going with 38's and a full 4" Clayton lift, or others dropping 25-35K on a built AluCab, not even including other fancy camping gear. That's bookoo bucks! I think the only real excess thing here is the rear winch - but half the time one needs to be pulled backward, not forward. I am opting for good ol Coleman and Amazon cheap camping gear (if I dont already own it) that does the same exact thing without triple the cost of the fancy 'overland' brand name things. 35's are decently respectable and can fit a stock rig. Some of the stuff like the compressor and electrical can be used for a lot more than just 'overloading' (or camping as it used to be called). I find use for the compressor all the time, just blowing stuff off. But also air down on just about every dirt road I drive, just for better comfort than anything else. Same with a water pump (not in place yet). It's super nice having the ability to rinse off boots after a muddy trail walk, or a dirty kayak, etc.... I see it as utilitarian given my living situation (no garage/shop). As for the skids...well, it's not just a weekend toy for me, and I'm making payments...., so I want to be sure things are protected in the unfortunate event of an impact. There's a bunch of stuff on there too, (like multiple different rims) to just see cost comparison and gauge what I really do want to get vs what will be left behind.

But I do think it's valuable to see where your cash goes. I'm doing the same thing for the house rebuild. It helps to really prioritize things better instead of "ooooo shinny!!"

Well said. I try to only buys what i actually needs. Things that gives me a better driving experience and safety. The wants or cool stuffs can wait.

With today's crazy and non sense world. My family's happiness and kids education are most important to me.

Sponsored

 

[Chuck]

Removed the spare, spare tire mount, and heat shield in prep for my new rear bumper with drawer.

 

[ShadowsPapa]

! I think the only real excess thing here is the rear winch - but half the time one needs to be pulled backward, not forward.

Not sure I'd call it excess. You can get pulled deeper and through a problem. or pulled back out of it, often more easily and quickly. There's a lot to be said for "pulling yourself back out" of a problem.

Same with a water pump (not in place yet). It's super nice having the ability to rinse off boots after a muddy trail walk, or a dirty kayak, etc....

I've many times wished for a way to wash mud off me before getting back into my truck........ not often enough in MY personal case, but...........

Anyway, I get your thinking - understand it. there are times I wish I was more like that, but it can never be. It's not possible, literally.

It helps to really prioritize things better instead of "ooooo shinny!!"

LOL - man, that reminds me of me. I had stickers and images posted on my office walls at work......... won't go there here.

 

[Dawgfan89]

Finally got the Mopar aux switch install sorted out (I blew a fuse during the install) and Rigid D-SS Side Shooters on the cowls.

Go Dawgs!

 

[jeepit]

have you found a spot / way to mount the 12v ?

Here is where i relocated the 12v outlet
below the driver side speaker

 

[ShadowsPapa]

Here is where i relocated the 12v outlet
below the driver side speaker

I need to find space in the center area - there, if anything was plugged in, it would get busted as I get in or out. Things that plug into 12v outlets tend to stick out a ways.
Would be nice if there was a way to add it to that way low down cubby in the center switch area that's worthless for anything but some spare change.

 

[RudeJeepin]

I need to find space in the center area - there, if anything was plugged in, it would get busted as I get in or out. Things that plug into 12v outlets tend to stick out a ways.
Would be nice if there was a way to add it to that way low down cubby in the center switch area that's worthless for anything but some spare change.

I seen a RedArc mounted there using their switch inserts, don't remember who. But maybe they will speak up as to which switch insert. I'm guessing it was the universal one. Not sure if it would fit the 12v plug or not.
Maybe a piece off poly or kydex would work.
In the end, the 12v plug is the main reason I went with the RedArc this time.

 

[Wvguard]

do you have the factory LED lights and if so did you have to do anything different with the tow lights kit?

 

[Gren71]

Here is where i relocated the 12v outlet
below the driver side speaker

Very cool look and great idea. Ive been letting this tumble around in my head and im thinking I want it on the center console still. Ive seen a few people on etsy who make parts for the center console and have been wondering if they’d be able to fabricate a piece to go over the small cubbyhole next to the OEM auxiliary switches. That little storage space is all but useless in my opinion and seems it would be a good spot to relocate the 12 V since it would require no extra wiring.

 

[Vtac2]

Picked up an iKamper 3.0 mini in Rocky black. Finish looks and feels durable. First open, easy, quality unit for sure. Pretty happy with it, can wait to get out and use it.

 

[dajudge]

Picked up an iKamper 3.0 mini in Rocky black. Finish looks and feels durable. First open, easy, quality unit for sure. Pretty happy with it, can wait to get out and use it.

Nice. What rack is that?

 

[Jefe1018]

I cussed at her... last bath was 4 months ago before I finally paid my mobile guy a good $100 to do the whole thing on Friday and guess what? It's raining today! She just doesn't like to stay clean.

 

[Vtac2]

Nice. What rack is that?

Extrusion overland. Solid quality rack. It gets allot of attention and questions from any enthusiasts in the market for an upgrade or acquiring a rack. Nothing but good things to say about the company.

 

[AyeCantSeeYou]

Got a BAK Revolver X4S tonneau cover installed this past Friday.

Dropping her off tomorrow morning to have a custom sound system installed. Gonna take 7 - 10 days. NOT looking forward to having a rental car.

 

[jeepit]

I need to find space in the center area - there, if anything was plugged in, it would get busted as I get in or out. Things that plug into 12v outlets tend to stick out a ways.
Would be nice if there was a way to add it to that way low down cubby in the center switch area that's worthless for anything but some spare change.

yup, it is a possibility,
it has gotten into yet maybe coz i don’t have anything that needs to kept plugged in. & i hardly use it except for air compressor once in a blue moon.

Sponsored