Which Mopar Tonneau Do you prefer?

[TinMan2020]

I recently bought this 2023 and am thinking of buying one of the three mopar bed covers. They have a hard trifold, soft trifold, and a really nice roll up (the way I’m leaning.)

I have done some research on cheaper aftermarket clamp on options and have seen reports of bent bed rails due to the clamps so I won’t be interested in those.

Thanks in advance.

Got pics of yours to share?

Sponsored

 

[NGNERD]

Don't have experience with others, but really like my factory roll up, find myself not wanting most racks because there not compatible though, but if rack is not a consideration then I recommend it.

 

[TinMan2020]

Don't have experience with others, but really like my factory roll up, find myself not wanting most racks because there not compatible though, but if rack is not a consideration then I recommend it.

I have decided against a bed rack.

 

[Reddout99]

Congrats, nice looking JT!

Since you've done your research, of the 3, the roll-up gives you the most bed accessibility, I'm not familiar with these, but does the last section of soft and hard tri-fold, closest to the cab, tilt up with supports to allow max access? The hard trifold would probably give you the most security for sure.
I am currently running a used off-brand soft tri-fold and don't have any issues.

 

[thejeepster]

Mopar hard tri-fold, closest section to the cab, does tilt up to give full access to bed-- (there's some youtube videos that show this)

I've got it on my gladiator and no issues- still like it better than soft cover just because we get a lot of wind, etc.

 

[drewcnit]

I've had the hard tri-fold since I bought the Jeep, it's great if you - want to securely haul things in the bed. It's bad at full bed-sized loads that cause you to fold up the last section against the rear cab/window.
Really depends on your use case and what you will be hauling in the bed. I love the tri-fold for the security aspect, but will be getting rid of mine in the next month because I'm going to a bobbed bed.
I'm in Middle TN, if you're close enough I'd meet you somewhere and let you check mine out, if you want to see one up close.

 

[jac04]

... but does the last section of soft and hard tri-fold, closest to the cab, tilt up with supports to allow max access?

The hard Mopar tri-fold that came on my 21 Mojave tilts up, but it does not have any type of supports to hold it up.

 

[Buckhorn]

I recently bought this 2023 and am thinking of buying one of the three mopar bed covers. They have a hard trifold, soft trifold, and a really nice roll up (the way I’m leaning.)

I have done some research on cheaper aftermarket clamp on options and have seen reports of bent bed rails due to the clamps so I won’t be interested in those.

Thanks in advance.

Got pics of yours to share?

I bought a Gator trifold hard cover from Realtruck. It is low profile, but does not flip up against the rear window. If I need the full bed I can loosen 4 knobs to remove the whole cover. If you want a soft trifold, check out the Gator one. It's not very expensive, and is simple to install and operate.

 

[BeckyLynne]

I recently bought this 2023 and am thinking of buying one of the three mopar bed covers. They have a hard trifold, soft trifold, and a really nice roll up (the way I’m leaning.)

I have done some research on cheaper aftermarket clamp on options and have seen reports of bent bed rails due to the clamps so I won’t be interested in those.

Thanks in advance.

Got pics of yours to share?

I just purchased a Bakflip mx4 it looks mint! Had it installed yesterday along with mint sill guards. I must get a pic for you all to see!

 

[katsrdking]

I have the hard tri-fold because I want a good trunk! The bed stays dry in downpours.

 

[Commodus]

I recently bought this 2023 and am thinking of buying one of the three mopar bed covers. They have a hard trifold, soft trifold, and a really nice roll up (the way I’m leaning.)

I have done some research on cheaper aftermarket clamp on options and have seen reports of bent bed rails due to the clamps so I won’t be interested in those.

Thanks in advance.

Got pics of yours to share?

I love my roll up, still looks new after 4 1/2 years with just annual maintenance. The only flaw was at 4 years the straps that sit below the tonneau disintegrated I believe their purpose was to make rolling the cover easier but I don’t mind not having them even though I’m sure they can be replaced if I wanted to have an interior shop to sew in new ones

 

[Viper501]

Mine came with an aftermarket tri-fold which I really appreciate. I normally do not need to fold it up and can use it for *more* secure storage of stuff in the back. I would *not* trust it or any of the MOPAR ones for true security of valuables for any period of time or in high risk locations. There are a number of higher security options out there that I’ve been looking at but haven’t decided I needed it enough to justify the expense.

I also suggest expanding your search outside of the MOPAR branded items since there are a lot of great options out there at lower price points than what those five letters require.

 

[Rusty PW]

I have the oem roll up. I like it. It keeps inside the bed dry.

 

[TinMan2020]

I love my roll up, still looks new after 4 1/2 years with just annual maintenance. The only flaw was at 4 years the straps that sit below the tonneau disintegrated I believe their purpose was to make rolling the cover easier but I don’t mind not having them even though I’m sure they can be replaced if I wanted to have an interior shop to sew in new ones

This choice makes the most sense to me. Thanks.

 

[JohnWick]

I also suggest expanding your search outside of the MOPAR branded items since there are a lot of great options out there at lower price points than what those five letters require.

My friend has a Tyger tri-fold and the quality appears to be the same at nearly 1/4 the price of the Mopar product. It's what I'm going to order for mine, although I am going to buy the roll-up so it's out of the way.

Sponsored