What did you do TO your Gladiator today? [ADMIN WARNING: NO POLITICS, NO GUN TALK]

[mdyucca]

MOPAR Trailer Brake Controller.

Holy back pain, Batman. Not technically difficult, but as with any under dash wiring, you've gotta be a contortionist to get it done.

And the sharp edges on the metal brackets under the dash! When complete it is a nice install. Looks factory!

Sponsored

 

[FloridaJT6MT]

Haha, I got one of those unsolicited emails from someone with no posts saying they have the Steel Mopar bumper I'm looking for.

Did they also have an extended warranty to sell you??

 

[exfil offroad]

Received and installed correct sway bar end links from my AEV 2" lift I've been needing for about a week. Ones that got shipped with the kit were the last thing I went to install, and could absolutely not get the OEM nut to thread onto the lower AEV mount (directions have you reuse OEM nut). On both sides, I got it about half an inch on before it started being incredibly difficult to tighten and eventually just stopped moving, and I realized the threat was stripping itself.

Huge shoutout to AEV for following up with their product though. I called the customer service and they explained that Jeep changed the specs on the bolt or nut on the lower end of the sway bar link, so the OEM nut didn't fit on the AEV link. They shipped me a new set of sway bar links with a correct nut, free of charge, no questions asked. Thanks AEV!

has that undercarriage ever seen dirt?

 

[HVYMETL]

Installed Armorlite, a dead pedal and seat jackers. Wasn’t hard, just a bit time consuming.

Thank you for the detailed pics. I was debating between these full floor liners and weathertech type. I am now leaning towards these. Anybody got a coin?

 

[1JeepFamily]

Added a class 3 Curt hitch receiver to my non-tow-package JTM with plastic bumper.

Pretty straightforward install. Followed this video to take off the bumper cover so I didn't have to drill a hole in the plastic bumper. Used the ol' AutoZone "rental program" to get a bit big enough for the top bolt (bent my poor-man's breaker bar in the process lol)and absolutely caked those bolts in blue loctite.

 

[NoDoorsNoProblem]

has that undercarriage ever seen dirt?

I drove from NJ to GA on Jan 7th when the whole east coast got walloped by a snowstorm, and had sooooo much ice, dirt, and salt caked up in there. I did NOT want my baby sitting with salt on it and starting to rust before it was even 6 months old, so I spent a good 2 hours at the DIY car wash getting as much off as I could

 

[869 KPH]

Where did you get the 1/4 panel 4x4 decals ?

Off the side of a 03-05 Dodge Ram? lol.

I used the ol' AutoZone "rental program" to get the HUGE bit size to wrench the top bolt down, and also bent my poor-mans-breaker-bar in the process lol. Absolutely caked the bolts in blue loctite.

Nice! Love that program. I think we got our breaker bars from the same place too, lol.

 

[DublF]

Put the clips on my visors before the inevitable.

 

[jeepers29]

Put the clips on my visors before the inevitable.

Mine should be here this week.

 

[1JeepFamily]

I think we got our breaker bars from the same place too, lol.

I've decided to upgrade to the black cast iron pipe propped in the corner of my garage ??‍?‍

 

[MikeyK]

What I did to my Gladiator today …
Stopped at the dealership to check if it’s being delivered this week or next ?

 

[XJFanatic]

Threw some sealight led headlights in. Haven’t had a chance to test them at night yet but so far impressed with the quality. I thought the bunker industries ones on the JL are great, these definitely have an even sharper cutoff. I will snap some pictures once it gets dark comparing them.

 

[SubiRubi]

I added the Rock Jock carrier bearing drop spacer. I've got 3.5" coil lift & 3/4" spacer out back. Sorry no b4 pics, it did have quite an upward tilt. For only $30 bucks & 1/2 hr, I feel better & so does the driveshaft.

I take it you don't have adjustable arms??

 

[Proximo]

Put the clips on my visors before the inevitable.

Ordered mine today, to repair the drivers visor and prevent the inevitable on the passenger visor

 

[Hurricane]

Put the clips on my visors before the inevitable.

Which clips and where did you order? Have already had to take the wife's JL in to get the passenger side repaired. It's still under warranty. Afraid the same will to my JT

Sponsored