coreoski
Well-Known Member
I'm using a Rocky mount axle clamp:Your truck and cap do look great! The weight of these caps are a real bonus.
What is the fork mount your using for your bike? Need to see if my E fattie will fit in the bed like that. Might have to air down the rear tire to close the tailgate....
https://rockymounts.com/collections/truck-mounts-adaptors/products/driveshaft-hm
I 3D printed some 2 piece brackets to hold a 2x4 right at the edge of the tailgate to maximize the amount of bed length I could use too:
https://www.jeepgladiatorforum.com/forum/showcase/squatch.229/#lg=1&slide=7
Not a perfect design, but it gets the job done and is very low profile.
Sponsored

)
