Flush Mount Tail Lights

[Dqban]

It's definitely thrown us for a loop. We prototyped on our 21 Rubi - LED Equipped, and the first off-tool units were also tested on a halogen Mojave. No issues.

The good news is, we're extremely close to having a "one size fits all" solution for both types (Halogen & LED) which will not require reconfig.

Bare with us everyone!

cant wait for the solution. My back up lights started randomly cutting out today . Coming from halogen.

Sponsored

 

[Wen_d]

Installed mine today on a 21 diesel overland with Led and safety equipped sensors. I have a tazer but did not need to adjust for the new tail light. So far seems pretty plug and play. No flickering. ??Hoping it stays good.
I just drove 50 miles and everything functioned appropriately.

 

[JP_Oracle]

Now y’all need to get busy on them racetrack lights! That tailgate blackout accented by racetrack lights meeting up with your flush mount tails would look super bad ass.

Yessir! The current design for the Racetrack lighting is a solid panel the same height as the flush tails. That will inherently also serve as a blackout. Two birds, one stone!

 

[bryanklay]

JP_Oracle

i did what you suggested and the turn signals work great but the blind spot monitor is unavailable. i am going to run wire on each tail light tomorrow afternoon to see if there is a wire misplaced. i also like the Racetrack lighting.
thank you for your time.
Bryan K. Lay

 

[JP_Oracle]

JP_Oracle

i did what you suggested and the turn signals work great but the blind spot monitor is unavailable. i am going to run wire on each tail light tomorrow afternoon to see if there is a wire misplaced. i also like the Racetrack lighting.
thank you for your time.
Bryan K. Lay

According to the Tazer manual, there is a "Set Blind Spot" setting in "Submenu Other" - Try making sure that is enabled.

 

[bryanklay]

yes i did check that to make sure that was set to yes as well. i am going to go into the body config today and compare to the body config of 9/ 20/2020 to see if there is any difference. i am doing this because both the front and rear cameras are not operational. this happened when i did the unmarried the Tazer and remarried to the vehicle.

 

[JP_Oracle]

yes i did check that to make sure that was set to yes as well. i am going to go into the body config today and compare to the body config of 9/ 20/2020 to see if there is any difference. i am doing this because both the front and rear cameras are not operational. this happened when i did the unmarried the Tazer and remarried to the vehicle.

Very strange but definitely sounds related. Perhaps there is a firmware update avail for the Tazer? Might be a good idea to check into that also.

 

[DirkG]

Yessir! The current design for the Racetrack lighting is a solid panel the same height as the flush tails. That will inherently also serve as a blackout. Two birds, one stone!

Suddenly the Jeep Gladiator became the Dodge Dakota (not bad though, just very Dodge)

 

[storrico]

Are their any works in place yet about accessories for people without the blind spot censors?

 

[JP_Oracle]

Are their any works in place yet about accessories for people without the blind spot censors?

Not quite sure what you're looking for here. Are you referring to adding BSM to a Jeep not equipped?

 

[storrico]

Not quite sure what you're looking for here. Are you referring to adding BSM to a Jeep not equipped?

A while ago it was said that in the future that people who do not have the blind spot censors Oracle would make accessories for people to buy to replace that section that is unused for some type of usage or I might just be making things up.

 

[KHam]

I received mine and have them installed (including the BSM) and no issues so far. Love the look and the backup light brightness is outstanding. The regular lights seem to be a bit brighter than factory as well. I'll throw my before and after pics on the pile here as well. I did not have any fitment issues.

Just my luck, apparently I am having some issues. The lights themselves appear to work perfectly and the more I see them the more I like them. They look awesome in the dark.

BUT, I see now that I get a fast blinker with using the turn signals even though I've confirmed they work fine and blink normally. And I do see a tail lights out warning. Mine came with all LED lighting and I did remove the resistor before installing. I also use the Taser but I haven't changed any settings regarding tail lights.

Are you all doing a disable then enable with the taser for the tail lights setting them to halogen and back again to fix this? I didn't think it was going to bother me that much but if there's a solution, that would be nice.

 

[JP_Oracle]

A while ago it was said that in the future that people who do not have the blind spot censors Oracle would make accessories for people to buy to replace that section that is unused for some type of usage or I might just be making things up.

Ah yes, sorry about that. Nothing officially in the pipeline yet, but we are working though a few ideas for this!

 

[JP_Oracle]

Just my luck, apparently I am having some issues. The lights themselves appear to work perfectly and the more I see them the more I like them. They look awesome in the dark.

BUT, I see now that I get a fast blinker with using the turn signals even though I've confirmed they work fine and blink normally. And I do see a tail lights out warning. Mine came with all LED lighting and I did remove the resistor before installing. I also use the Taser but I haven't changed any settings regarding tail lights.

Are you all doing a disable then enable with the taser for the tail lights setting them to halogen and back again to fix this? I didn't think it was going to bother me that much but if there's a solution, that would be nice.

Since you have the Tazer already installed, all you need to do is go in and follow the instructions below

 

[eaglerugby04]

Ah yes, sorry about that. Nothing officially in the pipeline yet, but we are working though a few ideas for this!

I can't imagine what would go here, but I would love to see some serious and joke ideas, lol.

Like who wouldn't want a snack holder inside their taillights, am I right?

Sponsored