Darkamek
Well-Known Member
Not a whole lot. Just three small cuts.Was there a lot to trim behind?
Sponsored
Not a whole lot. Just three small cuts.Was there a lot to trim behind?
Didn’t happen to take any pictures did you?Not a whole lot. Just three small cuts.
I didn’t take any pictures. Only takes a few seconds for you to pop the panel to see what is needed to trim though.Didn’t happen to take any pictures did you?
I’ll have to give it a look. Thanks!I didn’t take any pictures. Only takes a few seconds for you to pop the panel to see what is needed to trim though.
I did the same thing as here: https://www.jeepgladiatorforum.com/...ler-install-location.34519/page-3#post-654601Any pictures of how it was mounted?
sorry but I have to LOL, I literally almost did the same thing with my red arc!!Was so excited - this was the perfect location for the knob!
Used calipers to ensure even offset from the trim edges...was sure I had this nailed.
Was buttoning everything up...installing the last bit of trim.
You've got to be kidding me! Now to undo it all, and see how much of a hole I can see behind that trim piece...then start all over.
naw, it’s just the red arc is small as crap. That’s the only thing I would change about my Redarc, maybe 1/3-1/2 inch larger in diameter?That knob is HUGE! Haha.
No it goes dark when nothing is connectedDoes the Redarc control know have the LED light constantly on even when a trailer isn’t installed?
-that's what she saidThat knob is HUGE!