What did you do TO your Gladiator today? [ADMIN WARNING: NO POLITICS, NO GUN TALK]

[RudeJeepin]

Metal Cloak offers these as well. Very nice product. On sale as well right now.
https://metalcloak.com/upper-front-durostop-bump-for-the-jk-and-jl-wrangler.html

Any idea how the 2 products compare?

https://metalcloak.com/upper-front-durostop-bump-for-the-jk-and-jl-wrangler.html

https://www.northridge4x4.com/part/...raflex-progressive-bump-stop-kit-0-4-5in-lift

Sponsored

 

[Northridge4x4]

Personally its Foam. Both brands will basically be the same in my opinion. Choose the one you want to support the most.

 

[jn2275]

Should've posted last week after the install, but swapped out the factory sway bar for a '23 Rubicon disconnect unit, minus the motor. Manual knob to be delivered today. That'll give back about 20 minutes at the start of the trail and that much at the end of the trail as I don't have to manually disconnect the links each time.

Thanks for the idea. I grabbed this one off eBay with a damaged actuator. https://www.ebay.com/itm/314980012646

Curious which manual knob you went with? I see a bunch of JK ones and not sure if they're the same as JL/JT's.

 

[Mightytalldude]

Thanks for the idea. I grabbed this one off eBay with a damaged actuator. https://www.ebay.com/itm/314980012646

Curious which manual knob you went with? I see a bunch of JK ones and not sure if they're the same as JL/JT's.

There's a $24 aluminum unit on eBay that says JK but it works for the JL/JT sway bar without issue.
Check out For 07-17JK JKU Rubicon Electric Manual Swaybar Disconnect 1087 Aluminum New on eBay!
https://www.ebay.com/itm/3945867972...derpsqsxo&var=&widget_ver=artemis&media=EMAIL

 

[jn2275]

There's a $24 aluminum unit on eBay that says JK but it works for the JL/JT sway bar without issue.
Check out For 07-17JK JKU Rubicon Electric Manual Swaybar Disconnect 1087 Aluminum New on eBay!
https://www.ebay.com/itm/3945867972...derpsqsxo&var=&widget_ver=artemis&media=EMAIL

Awesome thanks man!

 

[Great Offender]

Thanks for the idea. I grabbed this one off eBay with a damaged actuator. https://www.ebay.com/itm/314980012646

Nice! By the time I went looking the pickings were slim. Installed a TerraFlex sway bar disconnect kit for the time being and realized two things. 1. I should have taken the tires off, 2. I think I'll install a lift in the spring.

 

[CampThree]

Found a place for an extra Mojave decal. Sometimes it's the little things.

 

[Martinnfb]

Added 3/4” spacer to the rear. Now it sits nicely level

 

[jeepers29]

Any idea how the 2 products compare?

https://metalcloak.com/upper-front-durostop-bump-for-the-jk-and-jl-wrangler.html

https://www.northridge4x4.com/part/...raflex-progressive-bump-stop-kit-0-4-5in-lift

I have only had experience with the MC product. It was a very nice bumpstop. I have used plenty of TF products and never been disappointed. I think you would be good with either choice. I know MC is having a sale right noe, so may be a few bucks cheaper.

 

[dwick37]

Swapped out the AALabs Fender Chop kit, and went with @Metalcloak.

Couldn't be anymore impressed with the quality. For my side amber light, it couldn't reach my Mojave fenders in width, so I just simply put a bolt there for more stability. ?

What front bumper are you running?

 

[Mojave20]

Installed Walcott antenna kit, Auxbeam switch panel, some 12v accessory power to the overhead panel & mounted my CB

 

[GobiGuy]

Installed a ProClip magnetic phone mount and XL RokBlokz front and rear.

 

[MojaveLawyer]

What front bumper are you running?

It's the ARB Bondi Deluxe

 

[biplaneguy]

I put the first real scratches in the bed, carrying lumber and steel reinforcing mesh for concrete. It really doesn't matter, it was inevitable sooner or later and I'm going with a spray in bedliner anyway, but it still seemed wrong to jam the sharp edges of the mesh against the front of the bed..

Earlier this morning I installed the inexpensive mud flaps I bought on Amazon, but I already described it in another thread.

 

[XraytecH]

Thanks for the idea. I grabbed this one off eBay with a damaged actuator. https://www.ebay.com/itm/314980012646

Curious which manual knob you went with? I see a bunch of JK ones and not sure if they're the same as JL/JT's.

Works on JKs JLs and JTs
https://evomfg.com/products/nolimits-manual-rubicon-swaybar-disconnect-jk-jl-jt

Sponsored