What did you do TO your Gladiator today? [ADMIN WARNING: NO POLITICS, NO GUN TALK]

[Bandit’s Lair]

That console cover is AWESOME!!!!!

Sponsored

 

[JonMN]

That console cover is AWESOME!!!!!

Thanks! I looked around quite a while before ordering. Goes on with two elastic straps, so no adhesive strips like some. Lots of options on this site: LINK

 

[Frankiestoys]

Gave Ricky his first ride. (9 weeks old) Thinking of renaming the Jeep "Bite Me."
DC

I finally got around to installing the Rubicon pull-offs that I got from a member here. They have been sitting around for a couple of years now. They drive nice. Much better than the 80k mile tire that were on it. Probably should have replaced the last year.

Picks?

 

[Frankiestoys]

Gave Ricky his first ride. (9 weeks old) Thinking of renaming the Jeep "Bite Me."

My daughter has one his name is Sunny . Great dog ! Not a bad bone in his body. Good luck he’s a very handsome boy.

 

[WILDHOBO]

I switched up the rotopax setup during this refresh. I’m mounting both towards the rear of the bed rail molle instead of the front two thirds, like I had it for several years. The main reason is that I have an idea for that front section. But I think I might like it anyway. It might create some sacrificial protection for the bed. I’d rather hit a storage container than the taillight. The last picture shows how it used to be.

 

[Lost1wing]

Picks?

Picks?

 

[BourbonRunner]

I gave it the first of many trips to Assateague National Seashore and its very own OSV permit sticker. (on the passenger side of the windshield)

 

[Mud Pie]

Got some 1.25" x 30' kinetic recovery rope and shackles to toss on my Molle panels. Cheaper and lighter than a winch, but sure don't look as cool.

I do have my Dad's come-along hand winch that I used when I was a kid to pull my Willys M38A1 engine/tranny/transfer case out, oh 50 something years ago. It thumped around in my old Jeep, wonder if I can find it and put it on my Molle just for old-times-sake.

 

[Rusty PW]

I gave it the first of many trips to Assateague National Seashore and its very own OSV permit sticker. (on the passenger side of the windshield)

Spent some time there with the first wifey and the Power Wagon. Good times.

 

[drewcnit]

I switched up the rotopax setup during this refresh. I’m mounting both towards the rear of the bed rail molle instead of the front two thirds, like I had it for several years. The main reason is that I have an idea for that front section. But I think I might like it anyway. It might create some sacrificial protection for the bed. I’d rather hit a storage container than the taillight. The last picture shows how it used to be.

I think I agree with you, they look better towards the rear and will be great sacrificial bumpers.

 

[ksoze]

That console cover is AWESOME!!!!!

Scored the same one last week!

 

[ksoze]

Bed Divider, scrap lumber, spray on bedliner, 4 d-rings on the back side.

 

[WILDHOBO]

I think I agree with you, they look better towards the rear and will be great sacrificial bumpers.

Thanks. Time will tell.

Sponsored