What menus did you use, can you screen shot them, also make sure you power cycle a couple times. I was pissed my first drive too. Then they magically worked, I attribute to the beer I drank thinking about it.
Do you have Jscan screen shots? From what I understand, there are two settings that need to be set using AlphaOBD so if you're only doing one of them in Jscan it may not work. It also took a couple of key on/off cycles for my settings to take affect.
Agreed! Makes me think the 392 wheel is less of a necessity.
So I activated the paddle shifters in two locations, under Misc settings and User settings. I don’t know what the difference between them is in JScan, I think one was paddle shifters, the other paddle shifters cms. They were the only two settings I could find relating to the paddles.
Agreed. I may try to come up with a custom made gasket to fill that space instead of cutting out the foam.
Did you have to do any cutting or trimming to get the paddle shifter to fit into the factory Mojave wheel hole? I think some kind of foam or rubber filler piece to fill that gap where the bezel sticks over would be good as well.1 down one to go,
Looks fancy, espically coz of the punched holes unlike stamped ones of SRTs.
waiting on back order, another paddle & wiring.
did a test fit on Mojave wheel & it seems to fit good enough, will be trying Jscan to activate once i get the back order parts
Let us know what you come up with!
Did you do an ECU reset afterwards? I know sometimes that helps.So I activated the paddle shifters in two locations, under Misc settings and User settings. I don’t know what the difference between them is in JScan, I think one was paddle shifters, the other paddle shifters cms. They were the only two settings I could find relating to the paddles.
move cycled through a couple of times already, I’ll check it again tonight when I leave for work
i didn’t do anything, just popped the old audio control & and put this paddle in, i am still waiting for wiring & right side paddle so didn’t even take the wheel out.
Looks like I’m not the only one! I’ve got a left paddle in the mail and I’m stuck on back order for the wiring and right paddle.1 down one to go,
Looks fancy, espically coz of the punched holes unlike stamped ones of SRTs.
waiting on back order, another paddle & wiring.
did a test fit on Mojave wheel & it seems to fit good enough, will be trying Jscan to activate once i get the back order parts
You can fit them to the Rubicon Wheel but they will sit a little proud like the Mojave above.
Beat me to it!
