Jeeperjamie
Well-Known Member
- First Name
- Jamie
- Joined
- Feb 12, 2020
- Threads
- 131
- Messages
- 4,650
- Reaction score
- 5,211
- Location
- Kannapolis nc
- Vehicle(s)
- 2020 jeep gladiator
- Occupation
- Weyerhaeuser
- Vehicle Showcase
- 1
Mine in my Max tow are pretty easy, but I'm a smaller dude, only 5 4 so that could be why. I can unplug them in less than a minute and have them plugged back in in less than a minute but the first time it took me about 20 minutes after that it's pretty easyYou went farther than I did...... It was 108 today so I did the minimum.
So I got the OBD scanner and security wire today too, and got it all connected to the JT and working.
In the app I set my tire height and then followed the instructions. After a test drive up to 60 everything matched up.
Although from the videos online the steps for the Gladiator were completely different. I wish the developer would use multiple sentences to explain what needs to be done or what should happen.
not just........."Turn off open door close door wait 5 minutes"
I don't know.... couldn't you put "what" I am turning off, the car, the plug... do I leave it plugged in.... some kind of message that says done..... and maybe ok safe to unplug now?
I was really scarred that I was going to screw something up, but it looks to all be ok and working perfectly.
Also, I don't know if its easier in another trim but those plugs are a bi#ch to get in and out on the Rubicon.
Sponsored