What did you do TO your Gladiator today? [ADMIN WARNING: NO POLITICS, NO GUN TALK]

[redfish]

Finally installed the rubi springs and shocks and .75 level in front. Think I am good for awhile?. Raised front 1.75” , still 1” of rake.

Sponsored

 

[mazeppa]

Sunrider installed.

While the top is new and it's warm out this can be removed with ease. May have to use some Goo Be Gone to remove a little of the adhesive.

 

[danelizer]

Mopar cold air intake. Took the scalpel to the hood. ?. Turned out great. Did not remove the hood for the install. A little more difficult but certainly doable. Definitely has a deeper sucking air noise when you put your foot in it but quite like stock when cruising.
I did this for fun, looks and because I could. ?

 

[XraytecH]

I thought the Mopar lift kept the rake. Definitely makes my decision easier if not the case.

Also factor in that I have DECKED storage box (≈200lbs) in the bed.

 

[ColoFreeJeeper]

Installed my BadgeGlow auxiliary switch board.

 

[Jason Oliver]

Fan of "The Expanse"? Nicely done!

 

[Wkyfiregladdy]

Installed the prp front seat covers on my gladiator, also installed my Lange coyote mirror anchors in… think I finally got all my add ons from my old gladiator on my new one

 

[Beewdawg]

Added a Terraflex 1.5" leveling kit. Super simple to do. Took about 2 hours with 2 people in the

driveway.

 

[Painkillerspe]

Swapped out the overland shocks for Rubicon take offs. Have not done the springs yet. Deciding on whether or not to do leveling kit.

 

[BlackDog]

Lange Coyote mirrors installed.

 

[BlackDog]

Picking up a few more metal ammo cans, I've installed rivnuts in one and bolted it directly to the MOLLE panel, really like the outcome.

I like that idea, might borrow it if I come across some ammo cans.

 

[mellendic]

Mopar rails?

yes they are the stock rails.

 

[Animal]

I like that idea, might borrow it if I come across some ammo cans.

$10 harbor freight ammo can, cheaper than the mil surplus store had em. 4x M6 rivnuts seem to hold really solid. I positioned it so I could still remove the cans lid and access my trail rails. To move it back more if need some spacers due to the bolt holding the MOLLE panel to the bed. Just using it for my rachet straps currently.

 

[JeepOfTheseus]

Took all day (with a friend helping), but got the Mopar 2” lift installed. Went incredibly smoothly, which was a huge relief after the fiasco with my first attempt (different kit). Unfortunately haven’t driven it yet because I need to finish the light bar install.

 

[Skull]

M.O.R.E rear rock slider bed steps and dead pedal…

Sponsored