Did you just tint the front ? Of did you double tint the rear and limo tint the front ? I've been curious about what % tint would match the rear windows and if ceramic or traditional tint matches best ?Got tint put on today.
Need some pics with the glow!This weekend i got BadgeGlows Aux board installed, wired up some Rough Country blsck series pods w/amber DRL and some gas struts for the hood.
Llumar IRX Ceramic Tint. 30% front, 15% rear/back. The back combined with the existing privacy glass brings it to about 5% equivalent (limo tint). The front looks a touch lighter most of the time but I expected that (I didn't want to go any darker than 30% in the front). Some angles it matches surprisingly close though.Did you just tint the front ? Of did you double tint the rear and limo tint the front ? I've been curious about what % tint would match the rear windows and if ceramic or traditional tint matches best ?
This is super coolMetalCloak Rear Sway Bar Reinforcement Bracket
Installed successfully but had to deviate slightly from MetalCloak's instructions.
For 2021 JTs, there is a bracket on both sides and a what looks to be heat shield on the driver side. The heat shield you have to toss, there is no room for it. You have to sandwich the reinforcement bracket between the frame rail and the OEM bracket. Also the bolt and washers that come with the bracket are not needed for 2021 JTs.
Hope this makes sense.
Would love to get more info as to how there are installed.Ran the wire harness and wired them to the Aux Switch 2
https://www.quadratec.com/sites/def...ch-LED-Offroad-Light-Install-Instructions.pdfWould love to get more info as to how there are installed.
That is OEM plastic front bumper, correct?
Great work and thank you for the post. Just got notice mine shipped yesterday.MetalCloak Rear Sway Bar Reinforcement Bracket
Installed successfully but had to deviate slightly from MetalCloak's instructions.
For 2021 JTs, there is a bracket on both sides and a what looks to be heat shield on the driver side. The heat shield you have to toss, there is no room for it. You have to sandwich the reinforcement bracket between the frame rail and the OEM bracket. Also the bolt and washers that come with the bracket are not needed for 2021 JTs.
Hope this makes sense.
Was looking to find how the fogs were mounted and led me to Mopar 82215428 Auxiliary Light Mount Brackets.
Washed it (and my wife's too)
I have a question that hopefully you, or someone who sees this, can answer. Because you have these 2 vehicles and bumpers. Any idea if the 10th anniversary steel rubicon bumper
(made for the JK i think) will fit a 22 rubicon gladiator? I found what I think is a good buy, but not making the drive until I know for sure. The seller says it will fit, but
BTW, love the nacho JT. Just traded my hellayella JL, for a granite JT.