Z96 High Pressure Fuel Pump Recall!!!!!!

[ToJTornottoJT]

After waiting and waiting for parts to be available I finally called the dealer.
I was told there is no parts to replace - it is a software update.
Seems odd to me

I have seen a thread somewhere on this "Software Update". One of the aftermarket tuners came up with this, I can't remember which one, and it just turns something off. I am trying to find the post now.

Sponsored

 

[NCJL]

I have seen a thread somewhere on this "Software Update". One of the aftermarket tuners came up with this, I can't remember which one, and it just turns something off. I am trying to find the post now.

https://www.jeepgladiatorforum.com/...ode-review-by-green-diesel-engineering.65339/

 

[NCJL]

After waiting and waiting for parts to be available I finally called the dealer.
I was told there is no parts to replace - it is a software update.
Seems odd to me

My recall notice says “new parts”. Thinking the software update had to do with the DEF system.

 

[ToJTornottoJT]

https://www.jeepgladiatorforum.com/...ode-review-by-green-diesel-engineering.65339/

EXACTLY! Thanks!

 

[Rusty PW]

After waiting and waiting for parts to be available I finally called the dealer.
I was told there is no parts to replace - it is a software update.
Seems odd to me

Maybe changing the operating mode.

 

[BlueScapegoat]

I would not need a parachute. I would need a helicopter lift. Are those hooks on the front and rear of the jeep rated for overhead lifting like on the hood of the hummer?

Just use the tie down loops already on the hood, and the trail rail system. It'll be fine.

 

[mrmo]

Your concern is valid- the pump is still not good… ??? edt will help. Eventually a cp3 retrofit will be available… read up on the cp4, it’s issues are by design.
EDT is Cheap insurance. It’s not going to hurt your emissions components, will help in efficiency by adding a couple cetane, and it will lube the pump a little.

if your concern is with warranty etc. while I’m not suggesting to be a scum bag if an issue does arise…. If something happens with my fuel pump etc. and The dealer Asks specifically if I used an additive- I would not confirm that I did or didn’t….. that’s on them to figure out. ???.
We run EDT in all 5 of our diesels every day…. Two tdi’s with cp4’s, the gladiator with the cp4, a 2.8 crd Liberty, and a 6.0 power stroke…. The 6.0 always has issues- but it’s satans motor and edt doesn’t help or make worse any of its issues….

Satans motor....lmao

 

[Rusty PW]

Satans motor....lmao

No....... think that goes to GM's first diesel pickup truck motor. It was cursed on the drawing board.

 

[am1978]

Still no updates

 

[Rusty PW]

Still no updates

..........and still not on the recall list.

 

[Curtjeep]

So, I've been following this thread, but I just noticed that I have a different recall code? It also shows that there is no repair for my Gladiator yet... my code is 23V-263?

 

[22EcoDs]

So, I've been following this thread, but I just noticed that I have a different recall code? It also shows that there is no repair for my Gladiator yet... my code is 23V-263?

That's the nhtsa code for this campaign. Same thing.

 

[Pwntiac]

There’s always next year, if we’re lucky

 

[Dougstdig]

Not sure when this came out, but it's another look and possibly what may be coming.

https://www.tiktok.com/t/ZT8RVhDjS/

 

[Free2roam]

Not sure when this came out, but it's another look and possibly what may be coming.

https://www.tiktok.com/t/ZT8RVhDjS/

WOW. Very informative. I wonder if the crank and plungers are hard chromed and polished? Or are they just polished? Wondering what part that other company is pinning so it doesn't fail? The plunger?

Sponsored